PPG-60403A500KG

Short Description:

Both sides of the device are equipped with high-precision grating sensors, which automatically average the measured displacement data to reduce human and traditional mechanical measurement errors.

The equipment is easy to operate, the output of displacement data and pressure value is stable, and all data changes can be automatically recorded by the software to generate reports and upload to the customer system. The measurement software can be upgraded for free for life.

Send email to us

Product Detail

Product Tags

Introduction

PPG-60403A500KG is suitable for measuring the thickness of lithium batteries and aluminum casing power batteries, as well as other non-battery thin products. It uses a servo motor to provide pressure to make the measurement more accurate.

Operating steps

1. Turn on the power of the device and the measurement software and set the measurement parameters

2. Manual feeding

3. Press the measurement button, after completion, the software automatically records the data and generates a report

4. Manual blanking to complete the test

The main accessories of the equipment

1 Device main body:

1.1) Electric control cabinet: power box, pressure sensing system, grating data control system, motor control system;

2.1) Pressurization method: the servo motor drives the up and down movement of the linear electric cylinder, thereby driving the upper platen of the thickness gauge, and then the force value signal set by the pressure sensor gives the precise value of the motor to control the pressure and grating of the upper and lower platens. displacement data.

2 Fixtures:

2.1) Upper and lower platen platform: the material is insulating material and will not conduct electricity, and the battery test product can be directly squeezed downward, so as to achieve the preset force value of the product or the actual measured force value of the product;

2.2) Numerical acquisition system: use a non-contact high-precision metal patch grating ruler with a resolution of 0.5um. Under the condition of motion pressure test, the thickness change data of the product is automatically recorded by the PPG software and imported into the data report to generate the customer system;

2.3) Safety grating: The human safety grating is installed at the entrance of the upper and lower platens to avoid personal hazards caused by personnel operating errors or failing to leave the platen in time. The safety grating will therefore automatically stop the machine in time.

Technical parameters

1. Equipment beat	≤30S/pcs (excluding pressure custom hold time)
2. Number of operators	1 person
3. Test pressure value	0-500kgf (maximum pressure fluctuation range ±3%)
4. Pressure mode	servo pressure, adjustable pressure. The speed of the upper platen can be adjusted and the speed of the upper platen can be set to press down in sections.
5. Resolution of pressure sensor	0.1kg, accuracy:±0.2%
6. Measuring area	400mm×300mm (marble material)
7. Measuring thickness	0-50mm, test lifting height:80mm
8. Grating resolution	0.0005mm
9. Single-point accuracy	±0.015mm (with 150×100×10mm PPG standard gauge block, put it between the upper and lower pressure plates, repeat the test 10 times at the same position, the fluctuation range is ±0.02mm)
10. Comprehensive accuracy	±0.03mm (with 150×100×10mm PPG standard gauge block, put it between the upper and lower pressure plates, measure the center position of the pressure plate and 5 points of the four corners of the pressure plate, single-point measurement value - standard Value fluctuation range ±0.04mm)